Just call me 'Eddy'

Eddy is the newest meter for ghost hunting and paranormal investigations with so much more to offer than its TOUGH exterior.


  • EMF change detection
  • Temperature change alert
  • Digital temperature readout
  • Geophone vibration detection


Plus new model features.


The new EDI+ has all this and more including:

  • Data graphing and logging
  • Pressure
  • Humidity
  • Display control
  • Sound alerts





Included in the EDI is a sensitive ultra-low electromagnetic field detector programmed to detect sensitive changes in ambient energy changes. Lights and audio tones will alert you to changes and intensity based on the fluctuations picked up.



The EDI contains an ambient temperature sensor with a real-time LED display.

Eddy utilizes two lights to alert when significant temp changes occur. If temperature changes sharply in a short period of time, indicative of something paranormal, the device will alert you with rapid blinking of the top red LEDs.




The EDI contains a highly-sensitive 3-axis geophone to pick up the slightest movements or vibrations. A touch on a table/surface the device sits on will show though via a series of lights along the bottom of the device. Like a graph the device will light up the amount of LEDs based on the intensity of the vibration or movement.


It's tough

The EDI unit is built solid. The device itself is built to last the hardest of investigations. Beyond that, Eddy has a removable rubber exterior to shelter it from drops. So, you can feel confident that Eddy will be able to withstand the test of time.

New EDI+

More Features.

More Info




The EDI was designed with an ambient temperature sensor. The temperature is displayed by an LCD on the top of the EDI. Next to the sensor probe are two LEDs. This will alert you by lighting up and blinking if there has been a sharp change in temperature. If the temperature registered on the EDI varies .5+/- degrees within 3 seconds this will trigger the alarm. Though we know a literal temperature variation of .5 degrees is not that indicative of something paranormal, the delay the sensor probe has to catch up to the ambient air temperature means that a registered .5 degree change within three seconds is caused by the air around the probe changing significantly more. The probe will register the correct temperature in a matter of a few more seconds. This allows us to immediately alert you of a significant temperature change before the device actually registers it.


Ultra-Low Frequency Smart EMF

This digital EMF sensor is programed to pick up frequencies from below the 30 Hz to above the 30 kHz range and analyzes the electro-magnetic data several times a second for change. This allows us to cut out any small EM noise around the device making the sensor to be extremely sensitive to change. This change in the EMF field around the device is registered with a visual response on two LEDs that change intensity when in contact with an electro-magnetic event. There is also an audible alarm. The speaker can be toggled on and off based on preference.


Geophone / Vibration detector

Accelerometer driven vibration detection measures movements on 3-axis allowing it to be more effective than traditional geophones. The five LEDs on the bottom light up based on the intensity of the vibration or movement detected. (.024 G's to .122 G's)


There is also a switch to toggle the geophone on/off if you would not like it to be responding to movements while in your hand.

All content copyright © 2017.                  EDI product logo a trademark of CenTex Paranormal. All rights reserved.